Do you want to connect your WiiM streamer to Beolab speakers?
Then you need the right cable and connection.
Because Bang & Olufsen speakers work differently than standard speakers, a correct connection is essential.
On this page we explain how you can easily create your
Connect WiiM Mini, Pro or Ultra to Beolab speakers — without interference and with optimal sound.
Step 1:
Which WiiM do you use?
WiiM Mini
Fits the AUX / Optical-In/Out (TV) (minijack) output
Suitable with RCA cable to Beolab (1/5/3000/4000/4500/5000/6000/8000/penta)
If the lab is connected to a tulip or rca, the sliders on the speakers are set to LINE
WiiM Pro / Pro+ / can be done in three ways.
RCA (tulip)
with adapter AV-TRSDIN8
Can be connected directly with Line cable (tulip/powerlink)
WiiM Ultra, just like the WiiM Pro+
RCA / Pre-out with tulip
via adapter AV-TRSDIN8
Or directly with tulip cable
Best sound quality and most options
Step 2:
How do you connect the Beolab?
Via RCA (tulip) – most commonly used
Suitable for: Lab1/5/3000/4000/4500/5000/6000/8000/Penta
simple
good sound quality
With Powerlink adapter/cable = original B&O connection
better integration with adapter cable AV-TRSDIN8
direct connection, just like via B&O master/center
stable operation with on/off function via trigger
And the speakers remain at R or L (slider R/L/LINE)
Finally,
Beolab types 3/9/11/4002/6002/8002, can be used with RCA to DIN7 powerlink (line cable), these speakers are set to LINE if this connection is used
Important to know
Not all Beolab speakers work with a trigger signal (5/50/90 do not)
Therefore, always use the correct cable or adapter
Common mistakes
Wrong cable → no sound
No trigger → speakers remain off
Bad cable → hum or noise
Which cable do you need?
View the right cables for your setup below:
RCA cables for Beolab
Powerlink cables
AV-TRSDIN8 adapters Specifically for B&O
Tulp/Rca cable to powerlink (din7=LINE)
Tested without interference
Fast delivery
“Can't figure it out? Contact us via WhatsApp or email”
