i.r.minijack-2-meter_

I.R. eye cable

I.R. receivers for connection to Bang & Olufsen

Minijack I.R. Eye,

Bosscom
Add to cart

Minijack with cable

1 X I.R Eye.

 

 

RJ45 I.R. Eye,

Mark: Bosscom
Add to cart
rj45-ir-kabel
Easy to apply using the RJ45 connector.
Plug and Play.
Cable have 1 x I.R. Eye.
 
Please note on the,
3 meters 2 X I.R. and the 10 meters 2 x I.R
are 2 X I.R. Led Eye's

Din7 I.R. kabel

Oneremote
Add to cart

This DIN cable is intended for connection to a Beolink Active I.R. receiver from B&O.

Cable length, approx. 5 meters.

RJ45 I.R. cable

Add to cart

I.R. Cable with RJ45 connector.

Lenght ca 5 meter



I.R. Cable

Cavus
Add to cart

Special cable to connect the I.R eye to specific required length, the DIN7 plug can be used for this.

Colors,

Yellow
White
Brown
Blue
Black

Cable thick, 4 mm

Diagram connection,

Lumberg DIN7 metal

Lumberg
Add to cart
Plug to connect an I.R. cable, Solder plug

I.R. Wall Mounting Plate, 2 plate..

Add to cart

Simple mounting plate to mount the IR module on the wall.

Set consists of:

1 X Wall (left on image)

1 X I.R. EYE plate (right on image)

2 X screw + plug

3 x small fixing screws.

1 X mounting screw

How it works.

Screw the plate with the 3 screws to the I.R. EYE (4 the screw is from the Earth, loosen this light, screw the plate between and tighten it again)

Screw the other plate to the wall, wood or the like and then slide the I.R. EYE over this plate, wood takes into account the cable as it comes out of the wall to first pass it through the 2 plates.

Finally, the fixing screw is tightened so that it can no longer be dismantled.

2 pieces present.